Buy access — see plans and pricing ›
Enroll
Same study guide and practice exams. You are choosing how long you can log in.
Prepare for Part 1 (Commercial and Industrial) of the PSI New Mexico EE-98 Electrical Contractor exam for the Construction Industries Division (CID). PSI gives Part 1 as 80 questions in 200 minutes, and you need 75% (60 points) to pass (PSI New Mexico Candidate Information Bulletin, dated 4/3/2026).
The exam is open book. You bring your own 2020 National Electrical Code (or the 2020 NEC Handbook), the 2020 New Mexico Electrical Code (14.10.4 NMAC) and the National Electrical Safety Code, 2007. Books must be bound and may be highlighted, underlined and indexed with permanent tabs only; references containing any writing are not allowed. Ugly’s, the American Electricians’ Handbook and the Lineman’s and Cableman’s Handbook are not allowed in the room. Code questions are based only on the listed edition, so study the 2020 NEC, not the 2023 edition.
The course follows PSI’s ten Part 1 subject areas and their item counts: General Knowledge and Electrical Installation Requirements (13), Services, Feeders, and Branch Circuits (10), Grounding and Bonding (10), Hazardous Locations, Special Occupancies, and Special Equipment (10), Conductors and Cables (8), Raceways and Boxes (8), Lighting, Signs, and General-Use Equipment (6), Motors, Transformers, and Generators (6), Overcurrent Protection (5) and New Mexico State Code (4).
You get a study guide with worked examples (commercial load calculations, conductor ampacity with correction and adjustment, overcurrent device sizing and taps, grounding and bonding conductor sizes, box and conduit fill, motor and transformer circuits) and short checks after each topic, plus four timed practice exams of 80 questions in 200 minutes built to PSI’s area counts. Every explanation names the NEC section or table, or the 14.10.4 NMAC amendment, to open and says why the closest wrong answer fails.
EE-98 is a three-part exam: Part 2 (Residential, 40 questions, 100 minutes) and Part 3 (Specialties, 50 questions, 135 minutes) are separate, and you must pass all parts. New contractor candidates also need the Business and Law exam or an approved course. This course covers Part 1 only.
